Skip to navigation Skip to content

  • INT. RUBBER EXPO CLEVELAND... THE SHOW MUST G...

    Currently we are presenting ourselve to a strongly interested expert community at the International Rubber Exhibition & Elastomer Conference in Cleveland. Many thanks to the...

    [more]

  • REVIEW OF IRANPLAST IN TEHRAN

    With numerous projects, we look back on a successful IRANPLAST. Together with our team from India, we presented at the largest and most important exhibitions in Iran, the vertical...

    [more]

ZeroWaste

ZeroWaste ITM
ZeroWaste ITM

A tremendous cost saving of                                   30 % to 50 % was realized

Latest ITM technology for runner-loss-free direct injection an integrated hydraulic needle shut-off system. Ideally suited to produce small seals with low waste. These ITM (Injection Transfer Moulding) pots enable many injection nozzles which is not feasible with standard cold runner systems. Additionally, a special software is used in order to run appropriate clamping profiles. The hydraulic surface ratios in the so-calles transfer chamber and the article deck underneath lead to a perfect mould compressing which may enable a rework-free article production.

Advantages

  • Temperature-controlled distributing pot with hydraulically actuated shut-off needles
  • Direct injection of precision articles without runner loss
  • Production solutions including zero-waste article manufacture are feasible

Which cold runner is the ideal one?